| Item Name | |
| Part Number/Trade Name | DT885 REDUCER (SOLVENT) |
| National Stock Number | 6850PDT885 |
| CAGE Code | 1RM36 |
| Part Number Indicator | A |
| MSDS Number | 193707 |
| HAZ Code | B |
| Manufacturer Name | PPG INDUSTRIES, INC |
| Street | 4325 ROSANNA DR |
| City | ALLISON PARK |
| State | PA |
| Country | US |
| Zip Code | 15101 |
| Emergency Phone | 304-843-4300 |
| Information Phone | 440-572-2800 (412) 492-5555 |
| Date MSDS Prepared/Revised | 11JAN03 |
| Active Indicator | Y |
| Appearance/Odor | NON-VISCOUS LIQUID W/ AN ODOR CHARACTERISTIC OF THE INGREDIENTS |
| Boiling Point | 172 - 338 F |
| Vapor Pressure | 27.2 |
| Vapor Density | >AIR |
| Specific Gravity | .845 |
| Evaporation Rate | 222 |
| Solubility in Water | 9.7 % |
| Percent Volatiles by Volume | 100 |
| Chemical pH | ND |
| Container Type | R |
| Container Pressure Code | 1 |
| Temperature Code | 4 |
| Product State Code | L |
| Flash Point | 41 |
| Flash Point Method | PMCC |
| Lower Explosion Limit | 1.5 |
| Upper Explosion Limit | NA |
| Extinguishing Media | USE NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) CLASS B EXTINGUISHERS DESIGNED TO EXTINGUISH NFPA CLASS IC FLAMMABLE LIQUID FIRES |
| Special Fire Fighting Procedures | WATER SPRAY MAY BE INEFFECTIVE. WATER SPRAY MAY BE USED TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE BUILD-UP & POSSIBLE AUTOIGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT. IF WATER IS USED, FOG NOZZLES ARE PREFERABLE. FIRE-FIGHTERS SHOULD WEAR SCBA & FULL PROTECTIVE CLOTHING |
| Unusual Fire/Explosion Hazards | KEEP THIS PRODUCT AWAY FROM HEAT, SPARKS, FLAME, & OTHER SOURCES OF IGNITION. INVISIBLE VAPORS CAN TRAVEL TO A SOURCE OF IGNITION AND FLASH BACK. DO NOT SMOKE WHILE USING THIS PRODUCT. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. CLOSED CONTAINERS MAY EXPLODE WHEN OVERHEATED. DO NO APPLY TO HOT SURFACES. TOXIC GASES MAY FORM WHEN THIS PRODUCT COMES IN CONTACT W/ EXTREME HEAT |
| Stability | YES |
| Materials to Avoid | AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG OXIDIZING AGENTS |
| Hazardous Decomposition Products | CARBON MONOXIDE; CARBON DIOXIDE |
| Route of Entry: Skin | U |
| Route of Entry: Ingestion | U |
| Route of Entry: Inhalation | U |
| Health Hazards - Acute and Chronic | [INGEST] HARMFUL IF SWALLOWED [EYE] CAUSES SEVERE EYE IRRITATION [SKIN] MAY CAUSE MODERATE SKIN IRRITATION. MAY BE ABSORBED THROUGH THE SKIN [INHALE] VAPOR AND/OR SPRAY MIST HARMFUL IF INHALED. VAPOR IRRITATES EYES, NOSE, & THROAT |
| Symptoms of Overexposure | EYE WATERING, HEADACHES, NAUSEA, DIZZINESS, & LOSS OF COORDINATION ARE INDICATIONS THAT SOLVENT LEVELS ARE TOO HIGH. [EYE] REDNESS, ITCHING, BURNING SENSATION & VISUAL DISTURBANCES [SKIN] DRYNESS, ITCHING, CRACKING, BURNING, REDNESS, SWELLING |
| Medical Cond. Aggrevated by Exposure | NA |
| Emergency/First Aid Procedures | [INGEST] DO NOT INDUCE VOMITING. GENTLY WIPE OR RINSE THE INSIDE OF THE MOUTH WITH WATER. SIPS OF WATER MAY BE GIVEN IF PERSON IS FULLY CONSCIOUS. [EYE] REMOVE CONTACT LENS & POUR A GENTLE STREAM OF WARM WATER THROUGH THE AFFECTED EYE FOR AT LEAST 15 MIN. [SKIN] RUN A GENTLE STREAM OF WATER OVER AREA FOR 15 MIN. A MILD SOAP MAY BE USED IF AVAILABLE. [INHALE] REMOVE FROM AREA TO FRESH AIR. IN ANY CASE IF SYMPTOMS PERSIST CONTACT POISON CONTROL CENTER, EMERGENCY ROOM, OR PHYSICIAN |
| Steps if Material Released/Spilled | PROVIDE MAXIMUM VENTILATION. ONLY PERSONNEL EQUIPPED W/ PROPER RESPIRATORY, SKIN, & EYE PROTECTION SHOULD BE PERMITTED IN THE AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED MATERIAL WITH SAND, VERMICULITE, OR OTHER NONCOMBUSTIBLE ABSORBENT MATERIAL & PLACE IN CLEAN, EMPTY CONTAINERS FOR DISPOSAL. ONLY THE SPILLED MATERIAL & THE ABSORBANT SHOULD BE PLACED IN THIS CONTAINER |
| Waste Disposal Method | WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE WITH FED, STATE & LOCAL ENVIRONMENTAL CONTROL REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF THROUGH AN APPROVED WASTE MANAGEMENT FACILITY |
| Handling and Storage Precautions | DO NOT STORE ABOVE 120 DEGREES F. STORE LARGE QUANTITIES IN BUILDINGS DESIGNED & PROTECTED FOR STORAGE OF NFPA CLASS IC FLAMMABLE LIQUIDS |
| Other Precautions | VAPORS MAY COLLECT IN LOW AREAS. IF THIS MATERIAL IS PART OF A MULTIPLE COMPONENT SYSTEM, READ THE MSDS FOR THE OTHER COMPONENT(S) BEFORE BLENDING AS THE RESULTING MIXTURE MAY HAVE THE HAZARDS OF ALL OF ITS PARTS. CONTAINERS SHOULD BE GROUNDED WHEN POURING. AVOID FREE FALL OF LIQUIDS IN EXCESS OF A FEW INCHES |
| Respiratory Protection | MAY BE PREVENTED BY ENSURING PROPER VENTILATION CONTROLS, VAPOR EXHAUST OR FRESH AIR ENTRY. A NIOSH APPROVED AIR PURIFYING RESPIRATOR WITH THE APPROPRIATE CHEMICAL CARTRIDGES OR A POSITIVE PRESSURE, AIR SUPPLIED RESPIRATOR MAY ALSO REDUCE EXPOSURE |
| Ventilation | PROVIDE GENERAL DILUTION OR LOCAL EXHAUST VENTILATION IN VOLUME & PATTERN TO KEEP THE CONCENTRATION OF INGREDIENTS |
| Protective Gloves | NEOPRENE RUBBER GLOVES |
| Eye Protection | WEAR CHEMICAL-TYPE SPLASH GOGGLES OR FULL FACE SHIELD WHEN POSSIBILITY EXISTS FOR EYE CONTACT |
| Other Protective Equipment | WEAR PROTECTIVE CLOTHING TO PREVENT SKIN CONTACT. APRON SHOULD BE CONSTRUCTED OF NEOPRENE RUBBER |
| Protect Eye | NO |
| Protect Skin | NO |
| Protect Respiratory | NO |
| Chronic Indicator | UNKNOWN |
| Contact Code | UNKNOWN |
| Fire Code | UNKNOWN |
| Health Code | UNKNOWN |
| React Code | UNKNOWN |
| Volatile Organic Compounds (P/G) | 7.0473 |
| Volatile Organic Compounds (G/L) | 844.5402 |
| Ingredient # | 01 |
| Ingredient Name | BENZENE, ETHYL- |
| CAS Number | 100414 |
| Percent | 1 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 100 PPM |
| Ingredient # | 02 |
| Ingredient Name | 2-PROPANOL, 1-METHOXY-, ACETATE |
| CAS Number | 108656 |
| Percent | 30 |
| OSHA PEL | NE |
| ACGIH TLV | NE |
| Ingredient # | 03 |
| Ingredient Name | BENZENE, METHYL- |
| CAS Number | 108883 |
| Percent | 20 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 50 PPM |
| Ingredient # | 04 |
| Ingredient Name | 2-HEPTANONE |
| CAS Number | 110430 |
| Percent | 10 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 50 PPM |
| Ingredient # | 05 |
| Ingredient Name | BENZENE, DIMETHYL- |
| CAS Number | 1330207 |
| Percent | 10 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 100 PPM |
| Ingredient # | 06 |
| Ingredient Name | 2-BUTANONE |
| CAS Number | 78933 |
| Percent | 20 |
| OSHA PEL | 200 PPM |
| ACGIH TLV | 200 PPM |
| Ingredient # | 07 |
| Ingredient Name | *VM & P NAPHTHA |
| CAS Number | 8032324 |
| Percent | 30 |
| OSHA PEL | NE |
| ACGIH TLV | NE |